Stamping High Speed Feeder Mold Material Line Height Adjustable

High-speed roller feeder installation method:

Precautions for trial installation:

1. Adjust the feeding height of the high-speed feeder and the height of the mold material line.

Adjustment method: first loosen the fixing screw of the feeder, rotate the adjusting screw up and down to the required position, and then lock the fixing screw.

2. After adjusting the height of the feeder, it is necessary to determine whether the rocker is horizontal when the punch is dead (ie, whether the upper and lower swing angles are the same). If the horizontal error is large, the pull nut is loosened and the rotary lever is adjusted to the rocker level.

3. When punching thin materials, if there is still a certain distance between the pressure plate and the lower mold, the guiding device must be made again so as not to bend the material.

4. the mold should be fixed with the roller 90 degrees, otherwise the material will be skewed, the feed has resistance, the pressure is not even, causing the length of the delivery is not the same.

Roller feeder thickness adjustment:

Pull the loose handle up, place the material between the upper and lower wheels, lower the release handle, and then loosen the thickness adjustment plate fixing screw.

Move the material thickness adjustment plate handle up and down, let the relaxation bracket swing about 5mm left and right, and then lock the material thickness adjustment plate fixing screw.

The tightness and feeding time of the high-speed feeder press spring:

1. The function of the pressure spring is to apply pressure to the upper wheel, so that the upper wheel can press the material and send the material out, and the material must not be slipped as a principle.

2. the feeding time is controlled by the eccentric disk, generally normal is from 9 points (270 degrees) -3 points (90 degrees) Note: The feeding time can be freely adjusted according to customer needs.

3. Relax the feed distance due to the set screw, and rotate the adjustment screw to scribe the required feed distance on the vernier scale.

Note: Stop the punch at the bottom dead center, draw a line on the material, place the punch and then go to the bottom dead center. A line is drawn on the material, and the measurement is repeated several times. Then, the material is sent into the mold, and the guide pin hole is punched when the punching machine moves, and then the punching time is over 3 points.
 

Specification:
 

Straigtening performance:
 

*1:(Pneumatic):Option in case of pneumatic mandrel expansion is provi